skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing rubber-metal bearing for final drive > < Removing and installing assembly carrier with final drive

Octavia Mk1

Removing and installing rubber-metal bearing for assembly carrier
Removing and installing rubber-metal bearing for assembly carrier
Special tools and workshop equipment required
t  Pipe section -MP 3-409-
t  Assembly device -MP 5-402-
t  Assembly device -T10030-
Removing
–  Raise vehicle.
–  Remove wheels.
–  Remove coil springs → Chapter.
–  Remove assembly carrier with final drive → Chapter.
   
–  Position the special tools.
–  Pull out the rubber-metal bearing by turning the spindle.
Install
  Note
t  The rubber-metal bearings are supplied as spare parts in a sealed plastic bag.
t  Do not use any rubber-metal bearings which have been stored openly!
  S42-0097
–  Mount the rubber-metal bearing with the special tools.
For the correct installation position of the rubber-metal bearing in the assembly carrier, the ribbed side must point in the -direction of the arrow B-.
The collar of the special tool -T10030/4--arrow A- points to the rubber-metal bearing -1-.
–  If necessary, coat the rubber-metal bearing with water for inserting.
  S42-0098
–  Position the rubber-metal bearing and the special tools on the assembly carrier.
–  Insert the rubber-metal bearing by turning the spindle.
-A- Ring spanner
–  The ribbed side of the rubber-metal bearing must point upwards -arrow-.
  Note
For removing and installing the front rubber-metal bearings on the assembly carrier, the spindle must be inserted from below.
Further installation occurs in reverse order.
–  Install assembly carrier with final drive → Chapter.
–  Bleeding Brake System → Chapter.
–  Setting the hand-brake → Chapter.
After installing, check the track and the camber on the wheel alignment tester, adjust if necessary → Chapter.
  S42-0099
Tightening torques:
Bracket to body
t  Use new screws!
75 Nm
Assembly carrier to body
t  Use new screws!
110Nm + 90°
Propshaft at final drive60 Nm
Shock absorber at trailing arm
t  Therefore the vehicle must be positioned on its wheels with the weight load of a person seated on the rear seat.
110 Nm
Pipe connection of brake line14 Nm
Wheel bolt120 Nm

   

Removing and installing rubber-metal bearing for final drive > < Removing and installing assembly carrier with final drive