Skoda Workshop Service and Repair Manuals > Octavia Mk1 > Drive unit | 1.4 ltr./44 kW Engine - Mechanical Components | Engine cooling | Removing and installing parts of the cooling system | Coolant regulator housing, removing and installing the coolant pipe at the rear

Removing and installing the front coolant pipe, coolant pump > < Removing and installing radiator|Install

Coolant regulator housing, removing and installing the coolant pipe at the rear

Coolant regulator housing, removing and installing the coolant pipe at the rear

Note

t	Draining and filling up coolant → Chapter.

t	Do not separate the coolant regulator housing otherwise the leak tightness of the coolant regulator housing is no longer guaranteed. If functional problems occur at the coolant regulator, the coolant regulator housing must be completely replaced → electronic catalogue of original parts.

1 -	to the expansion reservoir

2 -	towards top radiator

3 -	Coolant regulator housing

–	with coolant regulator

–	Start of opening approx. 88 °C

–	End of opening: approx. 103 °C

4 -	Coolant temperature sender -G62-

–	with coolant temperature gauge sensor -G2 -

5 -

“O” ring

–

replace

6 -	Retaining clip

7 -	to heat exchanger

8 -

20 Nm

9 -	to the front coolant pipe

10 -

10 Nm

11 -	to heat exchanger

12 -	The coolant pipe at the rear

13 -

Washer

S19-0110

Drive unit
1.4 ltr./44 kW Engine - Mechanical Components
Engine cooling / Removing and installing parts of the cooling system
Coolant regulator housing, removing and installing the coolant pipe at the rear

Removing and installing the front coolant pipe, coolant pump > < Removing and installing radiator|Install