skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the front sealing flange|Install > < Removing and installing the front sealing flange

Octavia Mk1

Removing
Removing
–  Remove the V-ribbed belt → Chapter 13-1.
–  Remove tensioning element for V-ribbed belt.
–  Remove the timing belt → Chapter 13-2.
   
–  Remove crankshaft toothed belt sprocket. To this end lock the toothed belt gear with counterholder -T30004- or -MP 1-310-.
  Note
When attaching the counterholder -MP 1-310- place 2 washers between toothed belt sprocket and counterholder.
–  Drain engine oil.
–  Removing oil pan → Chapter 17-2.
–  Unscrew front sealing flange.
–  Remove sealing flange, if necessary release by applying slight blows with a rubber-headed hammer.
–  Use a flat scraper to remove sealant residues on the cylinder block.
–  Cover the gasket ring with a clean cloth.
  S13-0156
–  Use a rotating plastic brush to remove sealant residues on the sealing flange (wear protective goggles).
–  Clean the sealing surfaces. They must be free of oil and grease.
  S13-0456

Removing and installing the front sealing flange|Install > < Removing and installing the front sealing flange