Octavia Mk1
Note
|
1 - | 25 Nm |
2 - | Tensioning device for ribbed V-belt |
q | swivel tensioning device for V-ribbed belt with open-end wrench to slacken the V-ribbed belt → Anchor |
3 - | Vibration damper |
q | can be installed only in one position |
4 - | 25 Nm |
5 - | Generator |
q | Push back threaded bushes for retaining bolts slightly to more easily position the generator against the bracket |
6 - | 25 Nm |
7 - | Support |
8 - | 45 Nm |
9 - | 25 Nm |
10 - | Hollow screw, 30 Nm |
11 - | Gasket ring |
q | replace |
12 - | Pressure line |
13 - | Gasket ring |
q | replace |
14 - | Vane pump |
q | for power-assisted steering |
q | to facilitate the positioning of the vane pump on the holder drive the threaded bushings of the retaining screws slightly backwards |
q | removing and installing → Chassis → Rep. Gr.48 |
15 - | Belt pulley |
q | for the vane pump on the power-assisted steering |
16 - | 25 Nm |
17 - | Fixing screw |
q | Replace screw with firmness 8.8 by screw with firmness 10.9 → Electronic Catalogue of Original Parts |
q | Screw with firmness 10.9: 40 Nm |
q | Combining different firmness is not permissible |
18 - | V-ribbed belt |
q | before removing mark running direction |
q | check for wear |
q | do not kink |
q | routing of ribbed V-belt on vehicles without air conditioning → Fig. |
q | routing of ribbed V-belt on vehicles with air conditioning → Fig. |
q | remove ribbed V-belt → Anchor |
q | install ribbed V-belt → Anchor |
|
Note
Note
|
Note
Note
|
Note
|