Octavia Mk1
Parts of cooling system engine side |
1 - | 15 Nm |
2 - | Coolant pump |
q | check smooth operation |
q | Check fitting position |
q | removing and installing → Chapter |
3 - | O-ring |
q | replace |
4 - | towards top radiator |
q | connection diagram for coolant hoses → Chapter |
5 - | to cylinder head |
q | connection diagram for coolant hoses → Chapter |
6 - | to the compensation bottle above |
q | connection diagram for coolant hoses → Chapter |
7 - | to heat exchanger |
q | connection diagram for coolant hoses → Chapter |
8 - | Exhaust gas recirculation radiator |
q | only on engines ALH with automatic gearbox |
9 - | from connection fitting |
q | connection diagram for coolant hoses → Chapter |
10 - | 10 Nm |
11 - | to the expansion reservoir |
q | connection diagram for coolant hoses → Chapter |
12 - | Top coolant pipe |
q | attached to the bulkhead |
q | connection diagram for coolant hoses → Chapter |
13 - | O-ring |
q | check tightness |
q | replace |
14 - | Coolant temperature sender -G62- |
q | with coolant temperature gauge sensor -G2- |
15 - | Retaining clip |
q | check tightness |
16 - | to heat exchanger |
q | connection diagram for coolant hoses → Chapter |
17 - | from heat exchanger |
q | connection diagram for coolant hoses → Chapter |
18 - | 10 Nm |
19 - | Connection fittings |
20 - | Coolant pipe |
q | connection diagram for coolant hoses → Chapter |
21 - | towards top radiator |
q | connection diagram for coolant hoses → Chapter |
22 - | to bottom compensation bottle |
q | connection diagram for coolant hoses → Chapter |
23 - | to bottom radiator |
q | connection diagram for coolant hoses → Chapter |
24 - | Connection fittings |
q | for coolant regulator |
25 - | Coolant regulator |
q | removing and installing → Chapter |
q | Check fitting position |
q | test: heat up regulator in a water bath |
q | Start of opening approx. 85°C |
q | finish with approx.105°C |
q | opening stroke at least 7 mm |
26 - | Oil cooler |
q | removing and installing → Chapter |