| –
| Insert the supplied assembly plastic sleeves -A- on the corresponding valve stem. This will prevent any damage to the new valve stem seals -B -. |
| –
| Insert the new valve stem seal in the insertion tool - MP1-306-. |
| –
| Oil the sealing lip of the valve stem seal and carefully slide into the valve guide. |
| –
| Remove assembly plastic sleeves. |
| –
| Reinstall valve springs and secure with collets. |
Note | t
| After carrying out work on the valve gear, carefully crank engine at least 2 revolutions to ensure that no valve touches the piston when the engine is started. |
| t
| After installing the camsaft, the engine must not be started for about 30 minutes. The hydraulic clearance compensation elements must settle (otherwise valves would strike the pistons). |
|
|
|
