Octavia Mk1
| Summary of components of exhaust turbocharger with component parts |
| Observe rules for cleanliness → Chapter. |
| 1 - | Oil feed line |
| q | before connecting fill the exhaust turbocharger on the connection fitting → Item with clean engine oil. |
| 2 - | Union nut, 22 Nm |
| 3 - | 22 Nm |
| 4 - | Connection fittings, 30 Nm |
| q | replace |
| q | Coat thread and ball sealing surface with -G 052 112 A3- |
| 5 - | 10 Nm |
| 6 - | Hollow screw, 25 Nm |
| 7 - | Gasket ring |
| q | replace |
| 8 - | Intake manifold |
| 9 - | Gasket |
| q | replace |
| q | Check fitting position |
| 10 - | Washer |
| 11 - | 25 Nm |
| q | replace |
| q | Coat stud bolts with -G 052 112 A3- |
| 12 - | Support |
| q | Exhaust turbocharger - cylinder block |
| 13 - | 40 Nm |
| q | tighten all bolts first of all by hand |
| 14 - | Connecting tube |
| q | Between turbocharger and air filter |
| 15 - | Intermediate flange |
| 16 - | Exhaust gas turbocharger |
| q | Can only be replaced complete with exhaust manifold |
| q | removing and installing → Chapter |
| q | Checking charge pressure control → Chapter |
| q | Charge pressure control valve and vacuum setting element for charge pressure control valve are parts of the turbocharger and cannot be replaced separately |
| q | After installing the exhaust turbocharger, run engine at idling speed for about 1 minute to ensure that oil is supplied to the exhaust turbocharger. |
| 17 - | Gasket |
| q | replace |
| 18 - | Connection fittings, 40 Nm |
| 19 - | Oil return line |
| q | to cylinder block |
| 20 - | 17 Nm |
| 21 - | Vacuum line |
| q | To the solenoid valve for charge pressure limitation - N75- |
| q | Connection diagram for vacuum hoses → Chapter |
| 22 - | 20 Nm |
| q | tighten all bolts first of all by hand |
| 23 - | 20 Nm |
| q | replace |
| 24 - | Shield |
| 25 - | Front exhaust pipe |
| 26 - | Support |
| q | for oil feed line → Item |
| q | Before installing attach the oil feed line |
