skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Xenon headlights with automatic regulation (System Litronic 4.1) - overall view > < Coding control unit

Octavia Mk1

Reading measured value block
Reading measured value block
   
Readout on display:
–  Enter 08 and confirm with the key Q.
  
Vehicle system test               HELP
Enter address word XX
Readout on display:
–  Enter code number of the desired display group and confirm with the key Q.
Now appears the measured value block in the display.
  
Read measured value block     HELP
Enter display group number XXX
Measured value block 001
Reading measured value block 1→← Readout on display
12.3 V11.2 V0 km/h0 
     
    State of motion
l  0 - Vehicle stationary (up to 5 km/h)
l  85 - Vehicle moves uniformly
l  255 - Vehicle does not move uniformly
   Vehicle speed
  Voltage terminal 56b
l  below 10.5 V the correct function of the lights is not assured
 Voltage tml. 15
l  below 10.5 V the correct function of the lights is not assured

   
Measured value block 002
Reading measured value block 2→← Readout on display
2.4 V2.10 V-0,5 %216 
     
    Actuation of the stepper motor
   Adaptation signal from master to slave has been sent
  Voltage on the rear sender (master - left headlight)
not assigned (slave - right headlight)
l  1.9 up to 2.3 V - front-wheel drive
l  3.5 up to 3.9 V - 4x4 vehicles
 Voltage on the front sender (master - left headlight)
not assigned (slave - right headlight)
l  2.3 up to 2.8 V - vehicle stationary without load

   
Measured value block 003
Reading measured value block 3→← Readout on display
4254   
     
     
    
  Voltage at the discharge lamp
l  45 up to 95 V, after through heating of the discharge lamp
 Power output at the discharge lamp
l  32 up to 65 V, after through heating of the discharge lamp

   

Xenon headlights with automatic regulation (System Litronic 4.1) - overall view > < Coding control unit