If the ignition was switched off between the interrogation of the fault memory and the deletion of the fault memory, no deletion of the fault memory occurs.
t
Carefully observe the work procedure, i.e. first read out fault memory and then erase.
Caution! ->
Fault memory was not interrogated
Readout on display:
After the read-out on the display the fault memory is only erased after approx. 5 seconds.
The fault memory is now erased.
–
→ Press key
–
Select function 06 and confirm entry with the Q key.
Note
Wait 1 minute before interrogating the fault memory again.
–
After interrogating and erasing the fault memory, conduct test drive and interrogate fault memory again → Chapter.
During the interrogation of the fault memory must appear: