Octavia Mk1
| Scope of delivery of the exchange component |
| 1 - | ATF pump with piston -B2- |
| 2 - | Components of the brake -B1- |
| q | → Anchor |
| 3 - | Reverse gear - clutch -K2- |
| 4 - | Adjusting washers for clutch play |
| q | adjusting washers of different colours, different thicknesses |
| 5 - | 1. up to 3rd gear - clutch -K1- |
| q | the clutches -K1- and -K3- can be pressed together |
| 6 - | 3. and 4th gear - clutch -K3- with turbine shaft |
| q | the clutches “K1” and “K3” can be pressed together |
| 7 - | Axial needle bearing with washer |
| 8 - | Free wheel with piston -B1- |
| 9 - | Components of the brake -B1- |
| q | → Anchor |
| 10 - | ATF strainer |
| 11 - | Slide valve body |
| Components of the brake -B1- |
| 1 - | Circlip |
| q | for support pipe -B2- |
| 2 - | Circlip |
| q | for overrunning clutch |
| 3 - | Free wheel |
| q | with piston -B1- |
| 4 - | Disc spring |
| 5 - | Pressure plate -B1- |
| 6 - | Inner plate -B1- |
| 7 - | Outer plate -B1- |
| 8 - | Adjusting washer |
| Components of the brake -B2- |
Note| The brake -B2- is available in 2 versions. |
| A - | Brake -B2- |
| q | Version with wave spring washer |
| 1 - | Wave spring washer |
| 2 - | Outer plate -B2- |
| B - | Brake -B2- |
| q | Version with retaining ring |
| 3 - | Retaining loop |
| 4 - | Adjusting washer |
| Clutches |
Note| The clutch -K1- and -K3- are available in 2 versions. |
| A - | Clutches-Pos. 3, 4, 5- are pressed together |
| B - | The clutches can be loosely inserted into each other |
| 1 - | Reverse gear - clutch -K2- |
| 2 - | Adjusting washers for clutch play |
| q | up to 3 adjusting washers can be installed |
| 3 - | 1. up to 3rd gear - clutch -K1- |
| 4 - | O-ring |
| 5 - | 3. and 4th gear - clutch -K3- with turbine shaft |
| 6 - | Axial needle bearing with washer |
| Slide valve body with ATF strainer |
| 1 - | Steel spring and screw |
| q | for actuator rod for manual slider |
| 2 - | Plug for free wheel |
| q | must be ordered separately, if needed. |
| 3 - | Slide valve body |
| q | without conductor foil |
| q | must be ordered separately, if needed |
| 4 - | Gasket |
| q | press onto the intake collar of the ATF strainer by hand |
| 5 - | ATF strainer |
| 6 - | O-ring |
| 7 - | O-ring |