skoda Workshop Repair Guides

Skoda Octavia Workshop Service and Repair Manuals

ABOUT US
Setting the shift mechanism > < Removing and installing shift housing

Summary of Octavia Mk1 Gearbox Control Cables and Shift Lever Components

III - Control cables, shift lever - Summary of components
III - Control cables, shift lever - Summary of components
  Note
Grease bearing points and contact surfaces with polycarbamide grease -G 052 142 A2-.
   
1 - Selector cable
q   to angle lever
2 - Nut, 20 Nm
q   always replace → Electronic Catalogue of Original Parts
3 - Rubber washer
4 - Shift cable
q   at shift lever
5 - Screw, 15 Nm
6 - Bolt
7 - Bearing plate
8 - Nut, 25 Nm
q   always replace → Electronic Catalogue of Original Parts
9 - Cap
q   Warm up cap before fitting (e.g. in hot water).
10 - Bush
11 - Selector housing
q   Insert into bearing plate after assembly of the complete shift lever
12 - Spring
13 - Guide bush
q   insert in bush Pos.  → Item
14 - Bush
15 - Circlip
16 - Bush
q   fits in one position only
17 - Selector angle plate
18 - Split pin
19 - Circlip
q   removing and installing → Fig.
q   for vehicles 08.99 ?
20 - Distance sleeve
q   for vehicles 08.99 ?
21 - Spring
q   for vehicles 08.99 ?
22 - Shift lever
q   The shift lever and shift lever guide are combined as one spare part
23 - Shift lever
q   The shift lever and shift lever guide are combined as one spare part
q   for vehicles 08.99 ?
24 - Damper plate
q   clip onto shift lever
q   Fitting position: the peg -arrow- points to the shift lever bearing

   
Removing and installing circlip
–  Pull the shift lever in -direction of arrow A- and at the same time use a screwdriver to press down the distance sleeve fully in -direction of arrow B- and remove the circlip.
  Note
Do not twist the distance sleeve when pressing down with the screwdriver. Carefully release the mounting slot in the shift lever for the circlip.
  V34-2958

Setting the shift mechanism > < Removing and installing shift housing