Skoda Workshop Service and Repair Manuals

Setting the shift mechanism as of 05.99 Special tools required t  Rig pin -T10027A-   Note t  The following are required for correct setting of the shift mechanism: t  Operating and transmission elements of the shift mechanism are in perfect condition. t  Shift mechanism operates freely. t  Gearbox, clutch and clutch control must be in perfect condition. l  Gearbox in Neutral.

–  Pull forward the locking mechanism at shift cable and at selector cable as far as the stop -direction of arrow 1- and then lock by turning to the left -direction of arrow 2-.   Note The control cable must be moved in the cable lock.

Fix the gearshift shaft as follows: –  Press the gearshift shaft downwards -direction of arrow 1-. –  When pressing down the gearshift shaft turn angle lever -A- in -direction of arrow 2-. t  The angle lever -A- must point vertically upwards.

–  Lift off collar upwards -arrows- and pull out to the rear. –  If present, pull sound absorption towards gearshift knob.

Fix the gearshift lever as follows: –  Insert rig pin -T10027 A- through hole -A- into hole -B-.

–  Turn locking mechanism at shift cable and at selector cable to the right up to the stop in -direction of arrow-. The spring pushes the locking mechanism into the initial position.

–  Turn angle lever -A- back to the initial position in -direction of arrow-. t  The angel lever -A- must be in a horizontal position.

–  Pull the rig pin -T10027 A- out of the holes -A- and -B-. –  Fit collar into the frame.