Octavia Mk1
| Summary of components - removing and installing control cables |
Note| Grease bearing and friction surfaces with Polycarbamide Grease -G 052 142 A2-. |
| 1 - | Shift cable |
| q | press onto shift lever guide |
| q | Fitting position → Chapter |
| 2 - | Selector cable |
| q | at selector angle plate |
| q | Fitting position → Chapter |
| 3 - | Lock washer |
| q | removing → Fig. |
| 4 - | Lock washer |
| q | do not damage cables when removing |
| 5 - | Shift housing |
| 6 - | Cable support |
| 7 - | Grommet |
| q | Mounting of cable support to gearbox |
| 8 - | Spacer |
| 9 - | 25 Nm |
| q | for cable support to gearbox |
| 10 - | Cable lock |
| q | for selector cable at relay lever |
| q | unlock for setting the shift mechanism |
| q | up to 12.00, replace after levering off the relay lever Pos. 14 |
| q | as of 01.01 with bored through holes, must no longer be replaced |
| q | is secured with a circlip |
| q | removing and installing → Chapter |
| 11 - | Cable lock |
| q | for shift cable at gearbox shift lever |
| q | unlock for setting the shift mechanism |
| q | up to 12.00, replace after levering off the gearbox shift lever Pos. 16 |
| q | as of 01.01 with bored through holes, must no longer be replaced |
| q | is secured with a circlip |
| q | removing and installing → Chapter |
| 12 - | Lock washer |
| q | removing → Fig. |
| 13 - | Bushing |
| 14 - | Reversing lever |
| q | Fitting position → Fig. |
| 15 - | Sliding shoe |
| 16 - | Gearbox shift lever |
| q | with balancing weight |
| q | insert in such a way that the interrupted spacing of the teeth matches the gearshift shaft → Fig. |
| q | after installing set shift mechanism → Chapter |
| q | Fitting position → Fig. |
| 17 - | 20 Nm |
| q | for gearbox shift lever |
| q | always replace → Electronic Catalogue of Original Parts |
|
|
|
|
