Octavia Mk1
| Removing and installing secondary shaft housing |
| 1) Adjustments need to be made when replacing these parts → Chapter. |
| 1 - | 10 Nm |
| 2 - | Cover |
| q | for secondary shaft housing |
| q | for cover made of aluminium with additional gasket → Fig. |
| q | for cover made of plastic with vulcanized gasket → Fig. |
| q | according to gearbox identification characters assign via the → Electronic Catalogue of Original Parts. |
| 3 - | Sealing ring |
| q | always replace → Electronic Catalogue of Original Parts |
| q | made out of various materials, assign according to → Electronic Catalogue of Original Parts |
| 4 - | Oil filler plug, 30 Nm |
| 5 - | Magnet |
| q | insert into cover Pos. 2 |
| 6 - | Gasket |
| q | no longer fitted on cover made of plastic |
| 7 - | 45 Nm |
| q | insert using locking agent -D 197 300 A1- |
| q | always replace → Electronic Catalogue of Original Parts |
| 8 - | Secondary shaft housing1) |
| q | dismantling → Anchor |
| q | installing → Anchor |
| q | Repair bearing of shank bevel gear → Chapter |
| q | the sealing surface was widened to insert the cover Pos. 2 made of plastic → Fig. |
| q | assign according to → Electronic Catalogue of Original Parts |
| 9 - | Oil filter |
| q | tighten to 35 Nm |
| 10 - | O-ring |
| q | always replace → Electronic Catalogue of Original Parts |
| q | insert with oil for Haldex coupling |
| 11 - | O-ring |
| q | always replace → Electronic Catalogue of Original Parts |
| q | insert with gear oil |
| q | replace → Chapter |
| 12 - | Adjusting washer S3 |
| q | Note thickness |
| q | Setting overview → Chapter |
| 13 - | Rear axle housing1) |
| q | Clean the threads of the pin screws to remove locking agent for attaching the secondary shaft housing |
Note
|
|
