skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Removing and installing cover for Haldex coupling of plate housing > < Removing and installing secondary shaft housing
Removing and installing differential gear and head bevel gear/drive shaft
   
Removing and installing differential gear and head bevel gear/drive shaft
1) Adjustments need to be made when replacing these parts → Chapter.
1 - Rear axle housing1)
2 - Pin screw, 10 Nm
3 - Oil drain plug, 25 Nm
q   with solenoid
4 - Oil filler plug, 25 Nm
q   Capacity → Chapter
q   Check the gear oil in the rear final drive → Chapter
5 - Bleeding (of air)
q   before removing the differential gear Pos. 9, pull out of the rear axle housing
6 - Support
q   for plug connection/wiring loom
q   different versions
q   assign according to → Electronic Catalogue of Original Parts
7 - 10 Nm
q   2 pieces
8 - O-ring
q   always replace → Electronic Catalogue of Original Parts
q   insert with gear oil
q   replace on installed rear final drive → Chapter
9 - Remove the complete differential gear
q   with cover → Anchor
q   install with cover, to do so tighten screw Pos. 16 crosswise in stages → Anchor
q   disassembling and assembling → Chapter
10 - 25 Nm
11 - Right flange shaft
q   removing → Anchor
q   drive in with a plastic hammer
12 - Circlip
q   always replace → Electronic Catalogue of Original Parts
q   removing and installing → Fig.
13 - Head bevel gear/drive shaft1)
q   Head bevel gear is paired with the shank bevel gear
q   according to gearbox identification characters assign via the → Electronic Catalogue of Original Parts.
q   Repair bearing of head bevel gear/drive shaft → Chapter
14 - O-ring
q   always replace → Electronic Catalogue of Original Parts
q   insert with gear oil
q   replace on installed rear final drive → Chapter
15 - Cover1)
q   removing → Anchor
q   installing → Anchor
16 - 25 Nm
17 - Circlip
q   always replace → Electronic Catalogue of Original Parts
q   removing and installing → Fig.
18 - Flange shaft left
q   removing → Anchor
q   drive in with a plastic hammer

   
Push out the old circlip from the flange shaft groove with the new circlip -A-.
  V34-2005

Removing and installing cover for Haldex coupling of plate housing > < Removing and installing secondary shaft housing