Octavia Mk1
| III - Summary of components - control cables up to 12.00 |
Note| Grease bearing and friction surfaces with Polycarbamide Grease -G 052 142 A2-. |
| 1 - | Shift cable |
| q | connect with the cable lock Pos. 18 |
| q | Fitting position → Chapter |
| q | after installing set shift mechanism → Chapter |
| 2 - | Selector cable |
| q | connect with the cable lock Pos. 11 |
| q | Fitting position → Chapter |
| q | after installing set shift mechanism → Chapter |
| 3 - | Lock washer |
| q | always replace → Electronic Catalogue of Original Parts |
| 4 - | Shift housing |
| 5 - | Lock washer |
| q | do not damage cables when removing |
| q | always replace → Electronic Catalogue of Original Parts |
| 6 - | 25 Nm |
| q | for cable support |
| 7 - | Cable support |
| 8 - | Grommet |
| q | for mounting of cable support to gearbox |
| 9 - | Spacer |
| 10 - | 25 Nm |
| 11 - | Cable lock |
| q | for selector cable at relay lever |
| q | replace after levering off from relay lever Pos. 12 → Electronic Catalogue of Original Parts |
| q | removing and installing → Chapter |
| q | after installing set shift mechanism → Chapter |
| 12 - | Reversing lever |
| q | Fitting position → Fig. |
| q | after installing set shift mechanism → Chapter |
| 13 - | Bushing |
| 14 - | Lock washer |
| q | always replace → Electronic Catalogue of Original Parts |
| 15 - | Sliding shoe |
| 16 - | Gearshift lever |
| q | with balancing weight |
| q | insert in such a way that the interrupted spacing of the teeth matches the gearshift shaft |
| q | after installing set shift mechanism → Chapter |
| q | Fitting position → Fig. |
| 17 - | 20 Nm |
| q | always replace → Electronic Catalogue of Original Parts |
| 18 - | Cable lock |
| q | for shift cable at gearbox shift lever |
| q | replace after levering off from gearshift lever Pos. 16 → Electronic Catalogue of Original Parts |
| q | removing and installing → Chapter |
| q | after installing set shift mechanism → Chapter |
