Octavia Mk1
Removing and installing gearbox housing and shift mechanism as of gearbox manufacturing date 19 05 3 |
1 - | Conical screw, 25 Nm |
2 - | Flange shaft with pressure spring |
q | removing and installing → Chapter |
q | complete → Chapter |
3 - | Screw cap |
4 - | Circlip |
5 - | Reversing light switch -F4-, 20 Nm |
6 - | Sealing ring |
q | always replace → Electronic Catalogue of Original Parts |
7 - | Oil drain plug |
q | pay attention to different versions → Fig. |
q | Internal serration screw, 45 Nm |
q | Allan screw, 30 Nm |
8 - | Sealing ring |
q | if present, always replace → Electronic Catalogue of Original Parts |
9 - | 45 Nm |
q | Locking screw for gearshift shaft |
10 - | Screw |
q | always replace → Electronic Catalogue of Original Parts |
q | pay attention to different screws and tightening torques |
q | Inner hexagon round head = aluminium screw: 8 Nm and torque a further 180° |
q | Outer hexagon head = steel screw: 15 Nm and torque a further 90° |
q | Steel screws as a replacement → Fig. |
11 - | Screw |
q | always replace → Electronic Catalogue of Original Parts |
q | pay attention to different screws and tightening torques |
q | Inner hexagon round head = aluminium screw: 8 Nm and torque a further 180° |
q | Outer hexagon head = steel screw: 15 Nm and torque a further 90° |
q | Steel screws as a replacement → Fig. |
12 - | Shift mechanism |
q | Disassembling and assembling the gearshift mechanism on the gearbox side as of gearbox manufacturing date 19 05 3 → Chapter |
q | remove with the gearbox installed: |
t | Remove battery and battery tray |
t | Remove control cables and gearshift lever |
t | Screw out locking screw Pos. 9, unscrew shift mechanism from gearbox |
13 - | 20 Nm |
q | always replace → Electronic Catalogue of Original Parts |
14 - | O-ring |
q | always replace → Electronic Catalogue of Original Parts |
15 - | Clutch housing |
q | Repairing → Chapter |
16 - | Gearbox housing |
q | Repairing → Chapter |
|