skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing drive plate > < Removing and installing the sealing flange on the belt pulley side|Install

Octavia Mk1

Removing and installing pressure plate
Removing and installing pressure plate
Special tools and workshop equipment required
t  Counterholder for clutch -MP1-221 (VW 558)-
   
–  Put the counterholder -MP1-221- into the bore hole on the cylinder block and screw onto the pressure plate.
–  Release screws for pressure plate.
  Note
Replace screws for pressure plate.
–  Tighten screws to 60 Nm + torque a further 90° (1/4 turn).
  S13-0234

Removing and installing drive plate > < Removing and installing the sealing flange on the belt pulley side|Install