skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing intermediate shaft > < Removing and installing drive shaft with inner tripod joint AAR2600i

Octavia Mk2

Removing and installing drive shaft with inner tripod joint AAR3300i
Removing and installing drive shaft with inner tripod joint AAR3300i
Removing:
–  Unscrew screw for securing the drive shaft to the wheel hub:
t  Hexagon screw → Chapter
t  Twelve-sided bolt → Chapter
  Note
t  At the same time the vehicle must not be standing on its wheels, otherwise the wheel bearing will be damaged.
t  If the screw is loose, the wheel bearings must not be loaded.
t  If the wheel bearings are loaded through the vehicle's own weight, the wheel bearing will be initially damaged. This shortens the life of the wheel bearing.
t  When moving vehicles with drive shaft removed, it is advisable to install an external joint instead of the drive shaft and tighten with a torque of 120 Nm.
–  Remove wheel.
–  Remove noise insulation → Body Work → Rep. gr.50.
–  Remove drive shaft screening from the engine (if present).
–  Unscrew the drive shaft from the flange/gearbox.
   
–  Unscrew the nuts -arrows-.
–  Pull the wheel-bearing housing with steering joint out of the track control arm.
–  Pull the drive shaft out of the wheel hub.
Installing:
Remove possible paint and/or corrosion residue from the thread/the serration of the outer joint
–  Insert outer joint as far as possible into the serration of the wheel hub.
  S40-0262
–  Screw steering joint to the track control arm -arrows-.
  Note
Make sure the boot is neither damaged nor twisted.
–  Position the inner joint of the drive shaft and initially tighten to 10 Nm crosswise.
–  Tighten the screws with internal serrations crosswise according to the specified torque.
–  Attach drive shaft screening to the engine (if present).
–  Install the noise insulation → Body Work → Rep. gr.50.
–  Tighten screw for securing the drive shaft to the wheel hub:
t  Hexagon screw → Chapter
t  Twelve-sided bolt → Chapter
  Note
At the same time the vehicle must not be standing on its wheels, otherwise the wheel bearing will be damaged.
–  Tighten wheel.
  S40-0262
Tightening torques:
Drive shaft to wheel hub with wheel bearing „hexagon screw“
t  Use new screw
t  Vehicle must not be standing on its wheels for tightening the screw
200 Nm + 180°
Drive shaft to wheel hub with wheel bearing „twelve-sided bolt“
t  Use new screw
t  Vehicle must not be standing on its wheels for tightening the screw
70 Nm + 90°
Drive shaft to gearbox mounting flangeTighten crosswise!
t  First of all pre-tighten to 10 Nm crossways
t  Use new screws!
M10 = 70 Nm
Steering joint to track control arm 
t  Track control arm made of steel casting
60 Nm
t  Track control arm made of steel sheet
100 Nm
Drive shaft screening25 Nm
Wheel bolts120 Nm

   

Removing and installing intermediate shaft > < Removing and installing drive shaft with inner tripod joint AAR2600i