Skoda Workshop Service and Repair Manuals > Octavia Mk2 > Axles, steering | Front suspension, drive shafts | Summary of components: assembly carrier, anti-roll bar, track control arm - aluminium assembly carrier | Removing and installing front left vehicle level sensor G78

Removing and installing front left vehicle level sensor G78

Removing and installing front left vehicle level sensor -G78-

The sensor must not be mechanically adjusted.

Removing:

Note

The axle in the illustration is removed for purposes of clear presentation.

–	Remove noise insulation → Engine; Rep. gr.10.

–	Disconnect the plug connection on the front left vehicle level sensor.

–	Unscrew nut -2- from track control arm (different versions).

–	Release screw -1- from the assembly carrier (different versions) and remove sender.

Installing:

Installation is carried out in the reverse order.

After installing:

–	Undertake the basic setting for beam range regulation → Vehicle diagnostic tester.

Tightening torques:

Front left vehicle level sensor -G78- at console	9 Nm
Front left vehicle level sensor -G78- at track control arm	9 Nm

Skoda Workshop Service and Repair Manuals