Octavia Mk2
| Summary of components of the wheel bearing |
| 1 - | Wheel hub with wheel bearing (3-point support) - FS III brake |
| q | removing and installing → Chapter |
| q | Sensor ring for ABS is built into the wheel hub |
| q | Assignment → Electronic Catalogue of Original Parts |
| 2 - | Wheel bearing housing (3-point support) - FS III brakes |
| q | removing and installing → Chapter |
| q | with integrated brake carrier |
| q | If the wheel-bearing housing is replaced, the vehicle must be aligned → Chapter |
| q | Assignment → Electronic Catalogue of Original Parts |
| 3 - | Suspension strut |
| 4 - | Screw |
| q | the tip of bolt must point in the direction of travel |
| 5 - | Front left wheel speed sensor -G47-/Front right wheel speed sensor -G45- |
| q | can be checked → Vehicle diagnostic tester in the guided fault detection system |
| q | Clean the inner surface of the hole before inserting the wheel speed sensor and coat with a solid lubricant paste -G 000 650-. |
| 6 - | Screw, 8 Nm |
| q | M6x16 |
| 7 - | Track rod end |
| 8 - | Cover plate |
| 9 - | Screw, 12 Nm |
| q | M6x12 |
| 10 - | Nut, 20 Nm + 90° |
| q | self-locking |
| q | replace after each removal |
| 11 - | Wheel bearing housing (4-point support) - FS III brakes |
| q | removing and installing → Chapter |
| q | with integrated brake carrier |
| q | If the wheel-bearing housing is replaced, the vehicle must be aligned → Chapter |
| q | Assignment → Electronic Catalogue of Original Parts |
| 12 - | Brake disc, internally ventilated |
| 13 - | Screw |
| q | replace after each removal |
| q | Screw = 200°Nm + torque a further 180° → Chapter |
| q | Turn twelve-sided bolt = 70 Nm + 90° → Chapter |
| when loosening and tightening the vehicle must not stand on its wheels |
| 14 - | Screw, 4 Nm |
| 15 - | Wheel hub with wheel bearing (4-point support) - FS III and FN3 brake |
| q | removing and installing → Chapter |
| q | Sensor ring for ABS is built into the wheel hub |
| q | different versions |
| q | Assignment → Electronic Catalogue of Original Parts |
| 16 - | Wheel bearing housing (4-point support) - FN3 brakes |
| q | removing and installing → Chapter |
| q | with bolted brake carrier |
| q | If the wheel-bearing housing is replaced, the vehicle must be aligned → Chapter |
| q | Assignment → Electronic Catalogue of Original Parts |
| 17 - | Screw, 70 Nm + 90° |
| q | M12x1.5x45 |
| q | replace after each removal |
| 18 - | Drive shaft |
| q | removing and installing → Chapter |
| 19 - | Nut, 70 Nm + 90° |
| q | self-locking |
| q | replace after each removal |