skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Repairing rear wheel suspension (vehicles with four-wheel drive) > < Summary of components: Anti-roll bar (vehicles with front-wheel-drive)

Octavia Mk2

Removing and installing the anti-roll bar
Removing and installing the anti-roll bar
Removing:
–  Remove rear wheels.
  Note
The following steps are described for the left side of the vehicle. The steps apply also for the right side of the vehicle.
   
–  Unscrew nut -1- and pull screw out of anti-roll bar and coupling rod -2-.
  S42-0247
–  Unscrew screws -arrows- for the clamp of the anti-roll bar.
–  Remove anti-roll bar.
Installing:
Installation is carried out in the reverse order. Pay attention to the following:
  Note
The bolted connection of the anti-roll bar and the assembly carrier must only be performed, if the measured dimension „a“ between the wheel hub centre and the lower edge of the wheel house is respected (unladen weight position)! → Chapter
–  Insert the anti-roll bar.
  S42-0175
–  Tighten screws -arrows- for the clamp of the anti-roll bar alternatively and uniformly.
  S42-0175
–  Insert screw into the coupling rod -2- and tighten the anti-roll bar and the nut -1-.
–  Installing and tightening the wheel.
  S42-0247
Tightening torques:
Coupling rod
t  Use new nut!
45 Nm
Clamp for anti-roll bar to assembly carrier
t  Use new screws!
t  Tighten in unladen weight position! → Chapter
t  Tighten bolts alternatively and evenly.
20 Nm + 90°
Wheel bolts120 Nm

   

Repairing rear wheel suspension (vehicles with four-wheel drive) > < Summary of components: Anti-roll bar (vehicles with front-wheel-drive)