skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

Removing and installing rear suspension > < Rear left vehicle level sensorG76 (Summary of components)
Remove and install rear left vehicle level sensorG76 in the vehicle
Remove and install rear left vehicle level sensor -G76- in the vehicle
Removing:
   
–  Unplug connector -1-.
–  Unscrew screws -2- and -arrows-.
–  Pull out the sender.
Installing:
Installation is carried out in the reverse order. Pay attention to the following:
The lever of the sensor must point towards the outer side of the vehicle.
–  After replacing the rear left vehicle level sensor -G76- carry out the basic setting of the headlight range control unit -J431- → Vehicle diagnostic tester in the function „Targeted fault finding“.
  S42-0219
Tightening torques:
Rear left vehicle level sensor -G76- to assembly carrier5 Nm
Rear left vehicle level sensor -G76- to bottom top suspension5 Nm

   

Removing and installing rear suspension > < Rear left vehicle level sensorG76 (Summary of components)