Octavia Mk2
|
| The -arrow- shows the direction of travel. |
| 1 - | Screw, 50 Nm + 45° |
| q | replace after each removal |
| 2 - | Bearing bracket |
| 3 - | Screw, 90 Nm + 90° |
| q | replace after each removal |
| q | determine → Anchor the fitting position of the bracket to the trailing arm before tightening the screw |
| 4 - | Coupling rod |
| q | connects anti-roll bar with trailing arm/wheel-bearing housing |
| 5 - | Screw, 90 Nm + 90° |
| q | observe the order of tightening up → Anchor |
| q | replace after each removal |
| q | determine → Anchor the fitting position of the trailing arm to the wheel-bearing housing before tightening the screws |
| 6 - | Trailing arm |
| q | removing and installing → Chapter |
| q | repairing → Chapter |
| 7 - | Screw, 8 Nm |
| 8 - | Rear right wheel speed sensor -G44-/Rear left wheel speed sensor -G46- |
| q | can be checked → Vehicle diagnostic tester in the guided fault detection system |
| q | Clean the inner surface of the hole before inserting the sensor and coat with a solid lubricant paste -G 000 650-. |
| 9 - | Wheel-bearing housing |
| q | removing and installing → Chapter |
| 10 - | Rubber-metal bearing |
| q | replace → Chapter |
| 11 - | Nut, 45 Nm |
| q | self-locking |
| q | replace after each removal |
| 12 - | Screw, 4 Nm |
| 13 - | Brake disc |
| 14 - | Dust cap |
| q | replace after each removal |
| q | extracting and inserting → Chapter |
| a professsional seal can only be achieved with a new dust cap |
| 15 - | Screw, 180 Nm + 180° |
| q | replace after each removal |
| 16 - | Wheel hub with wheel bearing |
| q | Sensor ring for ABS is built into the wheel hub |
| q | removing and installing → Chapter |
| Wheel hub and wheel bearing form one unit. It is clearance free, adjusting and repairs are not possible. |
| 17 - | Screw, 12 Nm |
| 18 - | Cover plate |