–
| Screw in the new screws for the steering gear -1- and -2- and tighten to the specified tightening torque. |
–
| Install the assembly carrier on the body → Chapter |
Note Make sure the steering gear boot is neither damaged nor twisted. |
Note
Note It is necessary to perform a vehicle alignment in the event of: → Chapter. |
–
| Check the steering wheel position during the test drive. |
Note If after the test drive and with the wheels pointing straight ahead the steering wheel is off straight, perform a chassis alignment → Chapter. |
If a new steering gear is installed, perform the basic setting of the power-assisted steering control unit -J500- and the steering angle sender -G85 - with the → Vehicle diagnostic tester |
|
|
|