Repairing electro-mechanical steering gear

Make

Skoda

Model

Octavia Mk2

Section

Axles, steering › Steering › Repairing electro-mechanical steering gear

Running gearRepairing electro-mechanical steering gear

Repairing electro-mechanical steering gear Removing and installing bellows → Chapter Removing and installing track rod → Chapter

1 -	Right track rod end

q	Inspect dust caps for damage and check that they are sitting correctly.

if a track rod end was replaced or removed and installed, the vehicle must be aligned → Chapter

2 -	Nut, 55 Nm

q	When tightening the nut, the track rod end must be counterheld with a wrench.

3 -	Spring strap clamp

4 -

Bellows

q	check for damage

q	must not be twisted after setting the wheel toe

5 -	Open warm-type clamp

q	replace after each removal

q	Clamp new open warm-type clamp with clamp pliers for steering gear e. g. -VAS 6199-

6 -	Track rod, 100 Nm

q	removing and installing → Chapter

7 -	Screw, 6 Nm

8 -

Gasket

9 -	Cover plate

10 -	Steering gear

q	with power-assisted steering control unit -J500-

q	can be checked in the guided fault detection system with → Vehicle diagnostic tester

q	removing and installing → Chapter

Right-hand drive as of CW 22/08 and left-hand drive as of CW 22/09

q	The 3rd generation power-assisted steering

q	the steering angle sender -G85- is integrated in the steering gear and cannot be replaced separately

q	with three point fixing at assembly carrier

11 -	Left track rod end

q	Inspect dust caps for damage and check that they are sitting correctly.

12 -

Support

q	not present on vehicles with 3rd generation steering gear

13 -	Rubber bearing

q	not present on vehicles with 3rd generation steering gear

14 -	Clamp with nuts

q	replace if thread is damaged

q	not present on vehicles with 3rd generation steering gear

01 Steering & suspension