| –
| Clamp the pressurized gas strut in the section -a = 50 mm- in the vice. |
WARNING | The pressurized gas strut must only be clamped in this area, otherwise there is a risk of accident! |
|
| –
| Saw open the strut cylinder in the first third of the total length of the cylinder, starting from the piston side edge. |
Note | t
| Wear safety goggles during the sawing procedure. |
| t
| Cover the sawn section with a cloth. |
| t
| Oil and cloth are disposed of in accordance with waste disposal requirements. |
| t
| After degassing, the pressurized gas spring can be treated as scrap. |
|
|
|
