skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Glazing/window mechanism > < Cut out opening for trailer coupling

Octavia Mk2

Drilling the openings for the parking aid sensors
Drilling the openings for the parking aid sensors
Predrill the openings
  Note
Avoid damage to the painted bumper side!
–  Removing the bumper → Chapter.
   
–  Pre-embossed circular recesses for the sensors are present in the bumper. Mark the openings for the hole in the middle.
  S63-0109
–  Drill the openings with a diameter of 4 mm.
Drill the openings for the sensors
–  Use a step drill in order to drill the opening (diameter 18 mm).
  S63-0110
–  Drill the openings from the outer side of the bumper with utmost precision. Remove possible burrs from the inside and clean the openings.
  Note
If the vehicle is also equipped with parking aid sensors in the front bumper, the work procedure is the same as for both rear bumpers.
  S63-0111

Glazing/window mechanism > < Cut out opening for trailer coupling