Octavia Mk2
Summary of components of rear bumper (Octavia Combi II) for vehicles up to 10.08 |
1 - | 1.5 Nm |
2 - | 8 Nm |
3 - | Right guide part |
4 - | 3.5 Nm |
5 - | Adjusting nut |
6 - | Body-bound rivet |
7 - | Bumpers |
Removing: |
– | Remove trim panel from bottom of pillar D → Chapter. |
– | Removing rear lights → Electrical System → Rep. gr.94. |
– | Remove both side trim panels in the luggage compartment and unscrew screws (Pos. 2). |
– | Remove screws (Pos. 8). |
– | Remove screws (Pos. 1 and Pos. 11). |
– | Remove expanding rivets (Pos. 6). |
– | Push rear bumper (Pos. 7) to the rear |
Note
Before removing the bumper it is necessary to disconnect plug of park sensors (if present). |
Installing: |
– | Installation is performed in the reverse order, pay attention to the following points: |
Note
Screws (Pos. 8) must be mounted successively from the centre of the bumper to the sides. |
8 - | 1.5 Nm |
9 - | Bumper strip |
q | Pressed on onto the bumper clips (Pos. 7) |
q | Is a component part of the rear bumper (Octavia Combi II RS) |
10 - | Rear spoiler |
q | Pressed on onto the bumper clips (Pos. 7) |
q | Is a component part of the rear bumper (Octavia Combi II RS) |
11 - | Left guide part |
12 - | 1 Nm |