skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing front passenger airbag key switch > < Installing and removing the acceleration sensor for side impact

Octavia Mk2

Removing and installing airbag system control unit
Removing and installing airbag system control unit
  WARNING
Safety regulations should be observed when handling the airbag units → Chapter.
Removing:
–  Disconnect battery earth strap → Electrical System → Rep. gr.27.
–  Removing the side covers of the centre console → Chapter.
   
–  Disconnect the plug fuse -2- in the -direction of the arrow- and remove the plug -3- from the control unit -1-.
–  Remove nuts -4- (9 Nm) and take out the control unit -1-.
Installing:
–  Installation is carried out in the reverse order.
  Note
t  The control unit must be newly coded when replacing the control unit for the airbag system → Vehicle diagnostic tester.
t  Pay attention to the sequence when connecting the battery → Electrical System → Rep. gr.27.
  S69-0145

Removing and installing front passenger airbag key switch > < Installing and removing the acceleration sensor for side impact