Skoda Workshop Service and Repair Manuals
HOME
FEATURES
MENU
INDEX
ABOUT US
Door trim panels >
< Removing and installing recessed handle on front passenger side (SCOUT)
Octavia Mk2
Body
Body Work
Trim, noise insulation / Dash panel
Removing and installing the central tube/dash panel
Removing and installing the central tube/dash panel
Removing and installing the central tube/dash panel
Removing:
Note
The work sequence may differ slightly on individual models depending on the equipment version.
–
Removing dash panel
→ Chapter
.
–
Disconnect plug connection for front passenger airbag
→ Chapter
.
–
Remove crash strut in front of the clutch pedal
→ Transmission System
→ Rep. gr.30
.
–
Remove the steering column from the central pipe
→ Chassis
→ Rep. gr.48
.
–
Remove the fuse and relay box from the central pipe
→ Electrical System
→ Rep. gr.97
.
–
Remove the convenience system control unit from the central pipe.
–
Remove air guide duct to the defroster vents and air guide duct for dash panel vents
→ Heating and Air conditioning
→ Rep. gr.87
.
–
Remove left footwell vent
→ Heating and Air Conditioning
→ Rep. gr.87
.
–
Remove the heating module carrier from the central pipe
→ Heating and Air Conditioning
→ Rep. gr.87
.
–
Remove fixing screws
-2-
(8 Nm) for right dash panel support
-1-
.
–
Remove fixing screw
-1-
(8 Nm) from the cross connection
-2-
and fixing screw
-3-
(6 Nm) from the fastening bracket
-4-
.
Note
t
As of 11/08 the cross connection (Pos. 2) is not attached to the supports with a screw (Pos. 1), but by means of welding seams.
t
Nothing was changed for the right-hand drive.
–
Remove fixing screws
-2-
(20 Nm) and
-3-
(8 Nm) for left dash panel support
-1-
and take out support downwards.
Note
t
As of 11/08 the supports (Pos. 1) are not attached to the central pipe with screws (Pos. 3), but are connected by welding seams.
t
Nothing was changed for the right-hand drive.
–
Remove fixing screws
-1-
(20 Nm) and
-3-
(8 Nm) for frequency support
-2-
and take out support.
–
Take cable harness out of central pipe.
–
Remove the plenum chamber cover
→ Chapter
.
–
Remove screw
-1-
(25 Nm) in the plenum chamber.
–
Release all electrical lines from the central pipe.
–
Remove fixing nuts
-1-
(25 Nm) and take out central pipe
-2-
to the front and towards the top.
Installing:
–
Installation is carried out in the reverse order.
Body
Body Work
Trim, noise insulation / Dash panel
Removing and installing the central tube/dash panel
Door trim panels >
< Removing and installing recessed handle on front passenger side (SCOUT)