skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and Installing Parts of the ABS System on the Rear Axle (four-wheel drive) > < Removing and Installing Parts of the ABS System on the Rear Axle (front-wheel drive)

Octavia Mk2

Removing and installing the ABS speed sensor on the rear axle
Removing and installing the ABS speed sensor on the rear axle
Removing:
–  Raise vehicle.
   
–  Separate plug connection -1- of ABS speed sensor/wheel speed sensor cable.
–  Release screw -2- from the wheel-bearing housing.
–  Take the ABS-speed sensor out of the wheel bearing housing.
Installing:
–  Clean the inner surface of the hole before inserting the ABS speed sensor and brush over the ABS speed sensor with a hot screw paste -G 052 112 A3-.
–  Insert the ABS speed sensor in the bore of the wheel-bearing housing and tighten the screw.
–  Connect the plug connection on the ABS speed sensor.
  S45-0147
Tightening torque:
ABS speed sensor in wheel-bearing housing8 Nm

   

Removing and Installing Parts of the ABS System on the Rear Axle (four-wheel drive) > < Removing and Installing Parts of the ABS System on the Rear Axle (front-wheel drive)