skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing brake light switch F and brake pedal switch F47 as of 11.05 > < Removing and installing bracket

Octavia Mk2

Setting, removing and installing the brake light switchF and brake pedal switchF47 until 10.05
Setting, removing and installing the brake light switch -F- and brake pedal switch -F47- until 10.05
  Note
Switch → Item mounted up to 10.05.
   
The removal and installation of the brake light switch must only be performed when the tappet is pressed otherwise the locking mechanism of the brake light switch will be damaged.
The brake light switch must be removed for setting.
Removing:
–  Removing driver side trim panel → Body Work; Rep. gr.70.
  S46-0158
–  Remove air duct -3-.
–  Unplug connector -1- from the brake light switch.
–  Remove brake light switch -2- by turning 45° to the left.
Installing and setting:
The brake light switch may only be installed once to ensure that it has an adequately tight fit.
–  Pull the tappet out completely before assembly.
  S47-0093
–  Guide the switch through the assembly opening, press against the pedal and attach by turning it 45° to the right.
–  The brake pedal always remains in the off position in this case (do not depress!).
–  Insert the plug for the brake light switch.
–  Inspecting proper operation of the brake light.
After setting up the brake light switch, check whether brake pedal is in the end position (release position).
–  Install air duct.
–  Installing driver side trim panel → Body Work; Rep. gr.70.
  S46-0159

Removing and installing brake light switch F and brake pedal switch F47 as of 11.05 > < Removing and installing bracket