Removing and installing brake caliper, brake caliper FN3 |
Special tools and workshop equipment required |
t
| Brake pedal load e.g. -V.A.G 1869/2- |
Note The procedure applies only for the replacement or for the following repair work on the brake caliper. |
–
| Lever up the retaining spring of the brake pads out of the brake caliper using a screwdriver and remove. |
–
| Disconnect the plug connection for the brake pad wear indicator. |
–
| Fit the bleeder hose of the bleeding bottle onto the bleeder screw of the brake caliper and then open the bleeder screw. |
–
| Position brake pedal load e.g. -V.A.G 1869/2-. |
–
| Close the bleeder screw and remove the bleeding bottle. |
–
| Unscrew the brake line. |
–
| Remove both caps out of the bushings of the brake caliper. |
–
| Loosen and remove the two guide bolts from the brake caliper. |
–
| Remove brake caliper from brake carrier |
–
| Take out the brake pads from the brake caliper. |
l
| The piston is pushed back. |
l
| The outside brake pad is fitted on the brake carrier. |
–
| Insert the inner brake pad with retaining spring into the brake caliper (piston). |
When installing the brake caliper make sure that the brake pad does not stick to the brake caliper before reaching its correct installed position. |
Do not damage the surface to be glued. |
–
| Screw the brake caliper with both guide bolts to the brake carrier. |
–
| Screw the brake hose onto the brake caliper. |
–
| Remove brake pedal load e.g. -V.A.G 1869/2-. |
–
| Insert retaining spring in brake caliper. |
–
| Mount the plug connection of the brake pad wear indicator. |
Note t
| Observe the instructions for changing the pad → Chapter |
t
| Forcefully apply the brake pedal repeatedly to ensure the brake pads go into their normal operating position. |
t
| Inspecting the brake fluid level. |
|
|
|