–
| Slightly pull fuel gauge sender 2 -G169 - out of the opening of the fuel tank, release catches -arrows- and disconnect suction jet pump. |
Caution When installing do not bend the float arm of the fuel gauge sender -2- -G169 -. |
|
–
| Insert the fuel gauge sender 2 -G169 - into the fuel tank. |
–
| Position the suction jet pump in the inside of the fuel tank onto the sender. The catches must click audibly. |
–
| Insert new dry gasket ring of the flange into the opening of the fuel tank and only now moisten the inside (towards flange) with fuel. |
–
| Pay attention to the fitting location of the fuel gauge sender -2- -G169- → Fig.. |
–
| Check correct seating of the gasket ring. |
–
| Tighten lock ring with wrench for union nut -T30101-. |
| Tightening torque: 110 Nm |
–
| Mount the plug connection. |
|
|
|