Octavia Mk2
Fuel distributor - Summary of component |
1 - | Injector |
q | Replace O-ring and combustion chamber gasket ring (Teflon gasket ring) |
q | pay attention to correct installation position |
q | removing and installing → Chapter |
2 - | Supporting ring |
3 - | Fuel distributor |
q | removing and installing → Chapter |
4 - | High pressure pump |
q | with fuel pressure regulating valve -N276 - |
q | Fuel high pressure line to high pressure pump: 17 Nm |
q | Install fuel high pressure line not under tension |
q | removing and installing → Chapter |
5 - | Roller tappet |
q | can remain stuck in the vacuum pump after removing the high pressure pump, removable |
6 - | Fuel pressure regulating valve -N276- |
7 - | 10 Nm |
q | replace |
8 - | Connection fitting for fuel feed line |
q | replace |
q | 25 Nm |
9 - | Union nut of the fuel feed line |
q | 18 Nm |
10 - | Separation plate |
11 - | Gasket |
q | replace |
12 - | Intake manifold |
q | removing and installing → Chapter |
13 - | Setting element for the intake manifold flap valve |
14 - | Throttle valve control unit -J338- |
q | with throttle valve drive for electronic power control -G186 -, angle sensor 1 for throttle valve drive for electronic power control -G187- and angle sensor 2 for throttle valve drive for electronic power control -G188- |
q | in case of replacement, erase initialisation values and adapt the engine control unit to the throttle valve control unit → Vehicle diagnosis, testing and information system VAS 5051 |
15 - | Screws for the intake manifold |
q | first of all pre-tighten all of them to 3 Nm and then tighten to 9 Nm |
16 - | Potentiometer for intake manifold flap -G336- |
q | when replacing, adapt engine control unit to potentiometer for intake manifold flap → Vehicle diagnosis, testing and information system VAS 5051 |
17 - | Fuel pressure sender -G247- |
q | 25 Nm |
q | Moisten thread with clean engine oil |
q | check → Chapter |
q | removing and installing → Chapter |