skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the camshaft (Octavia II) > < Checking the axial play of the camshaft (Superb II, Octavia II, Fabia II, Roomster)

Octavia Mk2

Replacing the gasket ring for the camshaft (Superb II, Octavia II, Fabia II, Roomster)
Replacing the gasket ring for the camshaft (Superb II, Octavia II, Fabia II, Roomster)
Special tools and workshop equipment required
t  Insertion tool -MP1-214 (10-203)-
t  Gasket ring extractor -T30003 (3240)-
t  Counterholder -T10051 -
t  Extractor -T10052-
t  Screw M12 x 65
Removing
l  Cylinder head attached at engine.
–  Remove the toothed belt Superb II → Chapter, Octavia II → Chapter, Fabia II → Chapter, Roomster → Chapter.
–  Remove the locking pin -3359-.
   
–  Unscrew bolts of camshaft sprocket -arrows- and remove camshaft sprocket from the hub.
  S13-0448
–  Loosen fixing bolt of the hub -1- approx. 2 turns, to do so use the counterholder -T10051-.
  S15-0307
–  Position the extractor -T10052- and screw the screws -1- into the hub.
–  Pull off the hub, to do so counterhold the hexagonal wrench (SW30) of the extractor and screw in the screw -2-.
–  Set the inner part of the sealing ring extractor -T30003 (3240)- flush with the outer part and interlock with the knurled screw.
  S15-0308
–  Oil the thread head of the gasket ring extractor, position and forcely screw into the gasket ring of the camshaft as far as possible.
–  Release knurled screw and turn the inner side against the camshaft until the gasket ring is pulled out.
–  Clamp gasket ring extractor into the vice and remove gasket ring with pliers.
–  Clean the contact and sealing surfaces.
Install
Installation is performed in the reverse order, pay attention to the following points:
  Note
The sealing lip of the gasket ring must neither be oiled nor greased additionally.
–  Remove oil residue from the camshaft stud with a clean cloth.
–  Cover slot on the camshaft cone with adhesive tape and carefully push the sealing ring onto the camshaft.
  S15-0169
–  Press in the gasket ring with the thrust piece of the insertion tool -MP1-214 (10-203)- and the screw M12 x 65 up to the stop.
–  Position hub onto camshaft.
  S15-0170
–  Tighten screw -1- to 100 Nm, use counterholder -T10051- to hold.
  S15-0307
–  Push camshaft sprocket onto the hub.
l  The tooth segment -arrow- of the camshaft sprocket must be at the top.
–  Slightly screw in plug -1-.
–  Interlock hub with locking pin e.g. -3359-.
–  Install the toothed belt (set the timing) Superb II → Chapter, Octavia II → Chapter, Fabia II → Chapter, Roomster → Chapter.
  S15-0371

Removing and installing the camshaft (Octavia II) > < Checking the axial play of the camshaft (Superb II, Octavia II, Fabia II, Roomster)