skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Disassembling and assembling pistons and conrods (Octavia II) > < Removing and installing crankshaft (Octavia II)

Octavia Mk2

Replace needle bearing for crankshaft
Replace needle bearing for crankshaft
Only on vehicles fitted with automatic gearbox.
Special tools and workshop equipment required
t  Interior extractor -Kukko 21/2-
t  Countersupport -Kukko 22/1-
t  Centering mandrel -T30029 (3176)-
  Note
For installing the engine for vehicles with automatic gearbox, check whether the needle bearing is built into the crankshaft. Install the needle bearing as required.
Removing
   
–  Pull out with interior extractor with countersupport -A-, e.g. Kukko 21/2 with Kukko 22/1.
Install
Fitting position of the needle bearing:
l  The marked side of the needle bearing (gasket ring side) should be legible when in its installed condition.
  S13-0471
–  Insert into the crankshaft with the centering pin -T30029 (3176)-.
  S13-0332
Depth of installation of the needle bearing:
t  Dimension -a- = 1.5 mm… 1.8 mm.
  S13-0472

Disassembling and assembling pistons and conrods (Octavia II) > < Removing and installing crankshaft (Octavia II)