Octavia Mk2
| Summary of components (Octavia ll) |
| 1 - | Sealing ring |
| q | replace → Chapter |
| q | Neither oil nor grease |
| 2 - | Sealing flange on the belt pulley side |
| q | must be positioned on dowel sleeves |
| q | removing and installing → Chapter |
| 3 - | Cylinder block |
| q | with fitted crankshaft |
| q | Replace needle bearing for crankshaft → Chapter |
| 4 - | The two-mass flywheel |
| q | removing and installing → Chapter |
| q | Assembly is only possible in one position through offset holes. |
| 5 - | 60 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 6 - | Intermediate plate |
| q | must be positioned on dowel sleeves |
| q | do not damage/bend during assembly work |
| q | inserted on sealing flange → Fig. |
| 7 - | 15 Nm |
| q | replace |
| 8 - | Sealing flange on the gearbox side |
| q | Always replace complete with gasket ring and if possible with rotor of engine speed sender -G28- |
| q | replace → Chapter |
| 9 - | Engine speed sender -G28- |
| q | removing and installing → Chapter |
| 10 - | 5 Nm |
|
|
