skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing cylinder head > < Cylinder head, vehicles with engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ

Octavia Mk2

Removing and installing cylinder head cover
Removing and installing cylinder head cover
Removing
   
–  Pull off the engine cover on the sides upwards -arrows-.
–  Detach the vacuum reservoir from the intake manifold.
  S10-0313
–  Remove the vacuum line -1- from the vacuum reservoir and push the vacuum reservoir to the side.
  S26-0220
–  Screw out screws -arrows-.
  A13-0558
–  Remove ignition coils with power output stages -2- → Chapter.
–  Detach the hoses -1- of the crankcase ventilation from the cylinder head cover.
–  Unscrew the fixing screws of the cylinder head cover from the outside to the inside.
–  Remove cylinder head cover.
Installing
Installation is carried out in the reverse order. Pay attention to the following:
  Note
Replace the gasket for the cylinder head cover when damaged.
–  Tighten the fixing screws of the cylinder head cover in several stages from the inside to the outside to 10 Nm.
  A15-0700
t  Tightening sequence of cylinder head cover:
–  Ensure that the top toothed belt guard is fitted correctly.
  S15-0384

Removing and installing cylinder head > < Cylinder head, vehicles with engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ