skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing the oil holder, engine identification character BWA > < Tighten and lock chain tensioner

Octavia Mk2

Removing and installing oil filter holder, engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ
Removing and installing oil filter holder, engine identification characters BLR, BLX, BLY, BVX, BVY, BVZ
Removing
–  Removing the intake manifold → Chapter.
–  Remove bottom coolant pipe → Chapter.
   
–  Remove oil cooler -arrows-.
  A17-0333
–  On vehicles up to 05.2005 detach the earth lead for the oil pressure switch.
–  Release screws -1- and -2- and remove the oil filter holder.
Install
–  Replace gaskets ( → Chapter, Pos. 4) and ( → Chapter, Pos. 15).
–  Insert baffle ( → Chapter, Pos. 14).
  A17-0334
–  Install oil filter holder, tighten screws -1- and -2- evenly to 15 Nm + torque a further 90° (1/4 turn).
  Note
On vehicles until 05.2005 the earth cable for the oil pressure switch must be fastened with the screw -2- and a cable strap at the guide tube for the oil dipstick.
  A17-0334
–  Install oil cooler -arrows-.
Further installation occurs in a similar way in reverse order to removal.
  A17-0333

Removing and installing the oil holder, engine identification character BWA > < Tighten and lock chain tensioner