Octavia Mk2
| Toothed belt drive - Summary of components, engines without split toothed belt guard |
| 1 - | 10 Nm |
| 2 - | Top toothed belt guard |
| 3 - | 50 Nm + torque a further 180° (1/2 turn) |
| q | replace |
| q | to release and tighten use counterholder -MP1-216 (3036)- |
| 4 - | Camshaft sprocket |
| q | Installation position fixed by woodruff key |
| 5 - | 10 Nm |
| q | insert using locking agent -D 000 600 A2- |
| 6 - | Rear toothed belt guard |
| 7 - | Woodruff key |
| q | check tightness |
| 8 - | 23 Nm |
| 9 - | Semi-automatic tensioning pulley |
| 10 - | Coolant pump |
| q | removing and installing → Chapter |
| 11 - | O-ring |
| q | replace |
| 12 - | 25 Nm |
| q | insert using locking agent -D 000 600 A2- |
| 13 - | Guide pulley |
| 14 - | 15 Nm |
| 15 - | 35 Nm |
| 16 - | Guide pulley |
| 17 - | Sealing flange |
| q | removing and installing → Chapter |
| 18 - | Diamond washer |
| q | for crankshaft - toothed belt sprocket |
| q | only fitted for engine identification character BWA |
| q | replace |
| 19 - | Crankshaft - toothed belt sprocket |
| q | there must not be any oil present on the contact surface between the toothed belt sprocket and the crankshaft |
| q | can be installed only in one position |
| 20 - | 90 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| q | do not oil |
| q | to release and tighten use counterholder -T30004 (3415)- or -MP1-310 (3036)- |
| 21 - | Toothed belt |
| q | mark the direction of rotation with chalk or a felt-tip pen before removing |
| q | check for wear |
| q | removing and installing → Chapter |
| 22 - | Bottom toothed belt guard |
| 23 - | Engine support bracket |
| 24 - | 45 Nm |
| 25 - | Cover for top timing belt guard |
