Octavia Mk2
| Fuel distributor with intake manifold flap motor -V157- - Summary of components, engine identification characters BVX, BVY, BVZ |
| 1 - | Low pressure pipe |
Note| t | when loosening, counterhold the pressure limiting valve |
| t | before installing, check that the pressure limiting valve has a tightening torque of 30 Nm |
| q | do not install under tension |
| q | Tighten union nut to 22 Nm |
| 2 - | 10 Nm |
| 3 - | Gasket |
| q | replace |
| 4 - | Fuel distributor |
| q | with intake manifold flap motor -V157- with intake manifold flap potentiometer -G336- |
| q | when replacing, adapt the engine control unit → Vehicle diagnosis, testing and information system VAS 5051 |
| q | removing and installing → Chapter |
| 5 - | CLIC-hose clamps |
| q | fasten with pliers für CLIC-hose clamps, e. g. -V.A.G 1723- |
| 6 - | Coupling piece |
| 7 - | High pressure pipe |
| q | do not install under tension |
| 8 - | Hollow screw with conical seal seating, 15 Nm |
| q | replace |
| q | pay attention to cleanliness |
| 9 - | 10 Nm |
| 10 - | 10 Nm |
| 11 - | Cable rail |
| q | with plug for the injection valves |
| 12 - | Pressure limiting valve, 30 Nm |
| 13 - | Fuel pressure sender -G247-, 22 Nm |
| q | Moisten thread and sealing cone with clean engine oil |
| q | removing and installing → Chapter |
| q | check → Chapter |
| 14 - | Cable strap |
| 15 - | Injection valve for cylinder 1 -N30- to injection valve for cylinder 4 -N33- |
| q | removing and installing → Chapter |
| 16 - | Separation plate |
