skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Checking and adjusting the unit mounting > < Installing the engine

Octavia Mk2

Tightening torques of the unit mounting
Tightening torques of the unit mounting
   
Unit mounting for engine
A - 20 Nm + 90° (1/4 turn) - replace
B - 40 Nm + 90° (1/4 turn) - replace
C - 60 Nm + 90° (1/4 turn) - replace
  S10-0275
Unit mounting for gearbox
1 - 40 Nm + 90° (1/4 turn) - replace
2 - 60 Nm + 90° (1/4 turn) - replace
  S10-0302
Pendulum support
A (strength category 8.8) - 40 Nm + torque a further 90° (1/4 turn) - replace
A (strength category 10.9 1)) - 50 Nm + 90° (1/4 turn) - replace
B - 100 Nm + 90° (1/4 turn) - replace
Remove: First release screw -B-, then screws -A-.
Install: First tighten screws -A-, then screw -B-.
  S10-0253
1) On manual gearbox MQ350 (02Q), only use the screws with the strength category 10.9 if bolt-holes have been installed (e.g. Heli-Coil) -arrow-.
  N34-10980

Checking and adjusting the unit mounting > < Installing the engine