skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing and installing coolant pump > < Removing and installing fan shroud for radiator fan V7 and right radiator fan V35

Octavia Mk2

Removing and installing radiator
Removing and installing radiator
Special tools and workshop equipment required
t  Catch pan for workshop crane, e.g. -VAS 6208-
t  Pliers for spring strap clamps
Removing
–  Switch off the ignition and pull out the ignition key.
  Note
Collect drained coolant in a clean container for proper disposal or reuse.
–  Drain coolant → Chapter.
   
–  Pull off coolant hose at top of radiator -arrow-.
–  Remove fan shroud with radiator fans → Chapter.
–  Unplug connector from high pressure sender -G65-.
  A10-1580
–  Screw out screws -arrows- and remove the radiator upwards.
Install
Installation occurs in reverse order to removal. Pay attention to the following:
t  Tightening torques: → Chapter
–  If a new radiator is installed, the old (drained) coolant must not be reused.
–  Top up coolant → Chapter.
  S19-0212

Removing and installing coolant pump > < Removing and installing fan shroud for radiator fan V7 and right radiator fan V35