Skoda Workshop Service and Repair Manuals

Removing and installing cylinder head cover Removing –  Remove engine cover → Chapter.

–  Unclip changeover valve for radiator of exhaust gas recirculation -N345--2- from the bracket. –  Release plug -1- and -3- and expose electrical cables. –  Release vacuum lines -4, 5, 6- and expose lines. –  Release screws -arrows-.

–  Detach the hose -1- of the crankcase ventilation from the cylinder head cover.

–  Remove the vacuum hose -1- from the cylinder head cover. –  Release screws -arrows- and remove holder.   Note The coolant hoses and fuel lines remain connected.

–  Remove top toothed belt guard; to do so release retaining clips -arrows-.

–  Release the screws of the cylinder head cover in the sequence -11 … 1-. –  Remove cylinder head cover with gasket. Install Installation occurs in reverse order to removal. Pay attention to the following:   Note Replace cylinder head cover gasket and cylinder head cover bolts if damaged.

–  First tighten the cylinder head bolts in the order -1...11-, then to 10 Nm.