Octavia Mk2
Note
|
| 1 - | Bearing shell |
| q | for cylinder block with lubricating groove |
| q | do not mix up used bearing shells (mark) |
| 2 - | Drive chain sprocket |
| q | for oil pump |
| q | removing and installing → Chapter |
| 3 - | Bearing shell |
| q | for bearing cap without lubricating groove |
| q | do not mix up used bearing shells (mark) |
| 4 - | Thrust washers |
| q | for bearing 3 |
| q | different version for cylinder block and bearing cap |
| q | pay attention to locating element |
| 5 - | 65 Nm + torque a further 90° (1/4 turn) |
| q | replace |
| 6 - | Bearing caps |
| q | Bearing cap 1: belt pulley side |
| q | bearing cap 3 with recesses for thrust washers |
| q | retaining lugs of the bearing shells of the cylinder block/bearing cap must be on top of one another |
| 7 - | Crankshaft |
| q | with chain sprocket for oil pump drive |
| q | Axial play when new: 0.07...0.17 mm; Wear limit: 0.37 mm |
| q | Crankshaft bearing pins: Ø 54.00 mm |
| q | Conrod bearing: Ø 50.90 mm |
