skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Removing toothed belt > < Summary of components - part 1

Octavia Mk2

Summary of components - part 2
Summary of components - part 2
  Note
Mark the direction of rotation with chalk or a felt-tip pen before removing the toothed belt. Reversing the rotation direction of an already used belt may destroy it.
   
1 - 120 Nm + torque a further 90° (1/4 turn)
q   replace
q   do not oil
q   to release and tighten use counterholder -T30004- or counterholder -MP 1-310 (3099)-
2 - 20 Nm
q   self-locking, replace
3 - small guide pulley
4 - 20 Nm + torque a further 45° (1/8 turn)
5 - Tensioning pulley
6 - Toothed belt
q   mark the direction of rotation with chalk or a felt-tip pen before removing
q   check for wear
q   do not kink
q   removing → Chapter
q   install (set the timing) → Chapter
7 - 25 Nm
8 - Toothed belt sprocket of exhaust camshaft
q   Check fitting position
9 - 25 Nm
10 - Toothed belt sprocket of inlet camshaft
q   Check fitting position
11 - 100 Nm
q   to release and tighten use counterholder -T10051-
12 - 100 Nm
q   to release and tighten use counterholder -T10051- → Chapter
13 - Hub
q   for exhaust camshaft
q   to remove use extractor -T10052-
14 - Hub
q   for inlet camshaft with rotor for hall sender -G40-
q   to remove use extractor -T10052- → Chapter
15 - Rear toothed belt guard
16 - Rubber grommet
q   for the removal of the hall sender -G40- (rear toothed belt guard must not be removed)
q   replace if damaged
17 - 10 Nm
q   insert using locking agent -D 000 600 A2-
18 - O-ring
q   replace
19 - Coolant pump
q   removing and installing → Chapter
20 - 15 Nm
21 - Toothed belt sprocket of crankshaft
q   there must not be any oil present on the contact surface between the toothed belt sprocket and the crankshaft
q   can be installed only in one position
22 - large guide pulley
23 - 90 Nm + torque a further 90° (1/4 turn)
q   replace
q   Attachment → Fig.

   
Adjust TDC for cylinder 1 with the belt pulley of the crankshaft fitted
–  Turn the crankshaft at the central bolt in direction of rotation of engine in such a way that the notch on the belt pulley of the crankshaft (TDC marking for cylinder 1) -large arrow- and the engraved arrow -small arrow- are positioned opposite each other on the middle toothed belt guard, as shown.
   Use a mirror.
  S13-0649

Removing toothed belt > < Summary of components - part 1