skoda Workshop Repair Guides

Skoda Workshop Service and Repair Manuals

ABOUT US
Checking the charge-air system for leaktightness > < Removing and installing charge air cooler

Octavia Mk2

Hose connections with push-fit couplings
Hose connections with push-fit couplings
  Caution
The gasket ring for the push-fit coupling can be damaged, if the locking clip is in the lock position during the assembly. This could result in a leakage. Observe the assembly instruction.
Removing
   
–  Release push-fit coupling by pulling the locking clip -arrow-. Disconnect hose/pipe without auxiliary tool.
Install
–  When replacing the gasket ring, place the gasket ring in the groove of the charge air hose. Make sure that the gasket ring is fully seated all round in the groove and not twisted.
–  Oil the sealing surface and the gasket ring.
  N21-0184
–  Put the locking clip into the release position -1-.
–  Push the charge air hose up to the stop into the coupling.
–  Put the locking clip into the lock position -2- and then press down once again the charge air hose.
–  Check for correct seating and the correct locking in place of the push-fit coupling by pulling on the hose.
  N21-10133

Checking the charge-air system for leaktightness > < Removing and installing charge air cooler