Skoda Workshop Service and Repair Manuals

Removing and installing air filter Special tools and workshop equipment required t  Pliers for spring strap clamps Removing

–  Remove cover for air intake connection, to do so release lateral retaining clasps -arrows-.

–  Release screws -arrows- for the air intake connection -1- and take air intake hose -2- out of the guide.

–  Press in catches -1- and -3- and pull off air intake hose -4- from air filter -2-.

–  Unplug connector -1- from air mass meter -G70-. –  Detach vacuum hose -3- and suction hose -2-. –  Slacken screw -4- and remove air filter housing. Remove suction hose   Note Due to the poor access of the pliers for spring strap clips to the bottom intake manifold it is preferable to remove the connection fitting from the exhaust turbocharger. –  Remove engine cover → Chapter.

–  Unclip hoses -2- and -3- from suction hose. –  Remove the connection pipe -1-.

–  Release screw -2-. –  Swivel connection fitting -3- in the -direction of the arrow A- and remove with the suction hose -1-. Install Installation occurs in reverse order to removal. Pay attention to the following: –  When attaching the connection fitting -3- at the exhaust gas turbocharger make sure that the connection fitting is correctly seated on the bolt of the exhaust gas turbocharger -arrow B-.